Find the source first
Dry and inspect the flysheet, floor, seams and attachments. Distinguish an external leak from condensation or an inner touching the wet fly. Check tension and ventilation. Repairing a coating cannot correct a poor pitch or lack of drainage.
Surface and seams
Surface water repellency and the main waterproof layer serve different roles. Do not apply a popular spray without checking its purpose. Peeling tape calls for assessment of the fabric rather than compulsory removal of every sound section.
Clean and prepare according to the chosen product and tent instructions. Generic advice to scrape with a knife, heat with an iron or use any alcohol may damage coatings.
Check coating type
Silicone and polyurethane surfaces need compatible products; opposite sides of one fabric may differ. Establish the marking and application side. Test an inconspicuous area and follow the specified working conditions and full curing time.
If the whole layer is failing
Stickiness, odour and widespread flaking call for assessing complete restoration. A local strip of adhesive does not replace a full coating. For extensive damage, consult a service centre and compare repair with replacing the component.
Checks after repair
Do not prescribe the same 8–12 hour drying time for every product or automatically dust everything with talc. After the specified cure, check the result before travelling. Store the tent clean and dry; carry compatible patches while recognising the limits of temporary repairs.